The building model check will check for possible modelling errors or mistakes. It is highly recommended to perform "Building Model Check" progressively when building the model so that problems are identified early in the project before running an analysis. Not all problems listed are errors. Some of them might be warnings which requires you to […]

Tutorial video of this topic is available at ProtaStructure 2025 Basic E-Learning: 14 Building Analysis, Axial Load Comparison Report A simple model can be created for a simple illustration of the Axial Load Comparison Report. The 3D view of the model is as above. The plan view of the model is as below. General information regarding […]

How to merge the results from sub-frame FE floor analysis and results from the 3D building analysis?   After a model is completed, a building analysis is mandatory which will generate results for G and Q (including the pattern cases of G and Q) as well as lateral load cases. This will be followed by FE […]

If a warning appears during analysis, indicating that nodes constrained by a diaphragm do not lie in the same plane, it should not be ignored : Warning: [DIAPHRAGMS] Diaphragm Nodes not in the same Plane. Nodes in different planes are constrained to move together, undesirable effects may accrue… The warning message is triggered when various […]

Various reports can be generated under " Drawings & Reports" tab. Pre-analysis Checks Report This report summarizes basic analysis model data such as storey heights, load combinations, materials and section properties. The member sections properties will only be included if the option to "Print Column, Wall & Beam Section Properties in Post-Analysis Report" is checked […]

In a typical building lateral resistance is provide at a few discrete points and it is assumed that applied lateral loads will be distributed to the lateral load resisting systems via floor diaphragm action. Within ProtaStructure diaphragm modelling is achieved using diaphragm constraints. A diaphragm constraint will maintain exact relative positioning of all nodes that […]

Options to be used in analysis can be specified in “Model Options” page of “Building Analysis” form. “Model Options” comprises of four tab pages namely, Model, Shear Wall Model, Slab Model, and Settings. Any modifications made in this page can be undone by pressing “Default Settings”. Model Parameters related with the analytical model of the building can be adjusted […]

Physical Model vs Analytical Model  The 3D model you built is a physical model with actual member size rendered visually.  The analysis converts the physical model into the analytical model (as shown below).     The analytical model is essentially a centre-line wireframe model. For members to be connected properly, the analytical wire frame must meet a […]

Automatic Assessment of Sway Sensitivity Sway sensitivity is automatically determined in ProtaStructure when the design code is set to EC2. For other codes as discussed below, an assessment of sway sensitivity can also be made, however it should be noted that this is based on analytical results and the recommendations of the ACI code. Whenever sway sensitivity is assessed […]

Introduction  During modelling structures, there may be situation where the beams insertion point is offset from columns insertion point.  In other words, the beam end node may not coincide exactly with the column node.  In ProtaStructure, as long as beams end node (insertion point) falls within the boundary of the column, rigid links will be […]